How to clean your dishwasher efficiently?

 

To keep your dishwasher working properly, it is important to have them cleaned in the right way. This will prevent the unit from getting damaged and keep the dishes coming out of it clean and fresh. You can use the following tips during the cleaning.

  1. Start by cleaning the exterior

When dishwashers are loaded with dirty dishes, some of the food particles can end up on the exterior surface. This gives the very foul appearance of the unit. It is best to have the exterior cleaned every time you use the machine. If the outside surface is made of plastic or steel, you can use a regular cleaner or some hot soapy water with a sponge. If the door is made of glass, specifically use a glass cleaner to remove the greasy spots and fingerprints. Instead of directly spraying the cleaning over the machine, spray it over the wiping paper or a towel. This will prevent the electrical components from getting damaged. Buy dishwashers

  1. Remove all the dishes

The best way to clean dishwashers is to run them through a full cleaning cycle, the required number of times. Therefore, make it a point that there are no dishes left inside before you prepare it for cleaning. After the machine is empty, place a bowl of vinegar and baking soda on the dishwasher safe container and run it through a hot water cycle. This will dissolve and clean away all the grime and grease that have been accumulating in the interior. You can also use a mild acid from time to time. Doing this every once in a month is sufficient.

  1. Cleaning the filter

Modernized dishwashers have a manual clean filter. The older models usually have grinders that break down the food particles and send them down the drain. This keeps the machine free from debris, but also creates a lot of noise. Using a filter can be noiseless, but also leads to a lot of food particles getting trapped on it, especially if you do not rinse the dishes before loading them on to the machine.

To clean the filter, remove it from the bottom rack and disassemble the interlocking parts. Soak these parts into the warm soapy water for about 10 minutes prior to cleaning. If there are some stubborn particles, you can remove them with a spray faucet or a tooth brush; however, do not use too much force as the filters are usually very fragile.

Also, check if the spray arm has obstructions. Cleaning with vinegar helps to unclog the holes from grease and calcification due to hard water. Make sure that both the filter and spray arms are clean before reassembling back the parts.

  1. Deodorize and sanitize

To deodorize, you can either use white vinegar or baking soda. This sanitizes the dishwashers as a whole. Leave a cup of vinegar before running a cleaning cycle disperse the vinegar evenly throughout the machine, thus deodorizing and sanitizing at the same time. You could also sprinkle some baking soda and vinegar overnight and rinse the following day.